11/3/2026

AI-generated illustration of a two-handed box lift observed by an ergonomics assessor.

The NIOSH Lifting Index (LI) compares a load's weight with the Recommended Weight Limit (RWL) for the measured task: LI = load weight / RWL.

A result above 1 means the load exceeds the recommended limit for those conditions. Review the task for improvements. The number does not predict whether a particular person will be injured.

Where the weight limit comes from

The Revised NIOSH Lifting Equation adjusts a load constant for horizontal and vertical hand location, vertical travel distance, asymmetry, lifting frequency and duration, and hand-to-object coupling. Less favorable conditions lower the RWL.

RWL = LC x HM x VM x DM x AM x FM x CM. LC is the load constant; the other terms are the six task multipliers. The constant of 23 kg (51 lb) applies to the equation's ideal conditions. It is not a universal lifting limit.

What a result of 1.5 means

Suppose the measured task has an RWL of 20 lb and the load weighs 30 lb. Dividing 30 by 20 gives an LI of 1.5. The load is 1.5 times the recommended limit for that task. It does not mean a 50% chance of injury.

Reducing the load to 20 lb, with all other conditions unchanged, would bring the LI to 1.0. Redesigning the task could also change the RWL. These numbers illustrate the calculation; they are not a completed workplace assessment or a customer outcome.

Use the result with its limits

  • An LI at or below 1 means the load is at or below the calculated RWL. Risk can still remain for some workers, and the method does not cover every hazard.
  • An LI above 1 means the load exceeds the calculated RWL. Higher values indicate greater demands relative to the recommended limit.
  • If measurements are incomplete or the task falls outside the method's scope, do not treat the displayed result as a valid assessment.

NIOSH recommends an LI, or a Composite Lifting Index where appropriate, at or below 1. That guidance helps with task design. It does not certify an individual's lifting ability.

Find the conditions you can change

Check which factors reduce the RWL. A long reach, twisting, unfavorable work heights, frequent lifting, and a difficult grip suggest different changes. Smaller multipliers show where the equation lowers the weight limit. Consider whether a proposed change is practical and how it affects the rest of the task.

Measure at the origin and, when significant control of the load is needed, at the destination. Re-grasping, briefly holding the load, and carefully positioning it are examples of destination control. Use the limiting result rather than the more favorable end of the lift.

When another assessment is needed

The ErgoFactor public calculator evaluates one two-handed lifting task. The RNLE has assumptions and exclusions, including one-handed lifts, seated or kneeling lifts, unstable loads, restricted workspaces, and lifting beyond the method's duration limits. Carrying, pushing, pulling, and other exposures need additional consideration.

Substantially different lifting tasks may need a multi-task analysis. A Composite Lifting Index is not the average of separate task Lifting Indices; the NIOSH manual gives a separate procedure.

Use the free ErgoFactor NIOSH calculator for a suitable single task. For mixed tasks or help interpreting the work as a whole, talk with ErgoFactor. For the broader process, read What Is an Ergonomic Risk Assessment?

Sources