11/3/2026

AI-generated illustration of hand-tool assembly and carton handling at separate workstations.

Use the Revised NIOSH Lifting Equation for a two-handed lifting task that fits its assumptions. Use the original Strain Index for repetitive hand and wrist work. The methods assess different exposures, so their scores are not interchangeable.

For lifting tasks: NIOSH

The Revised NIOSH Lifting Equation uses the load and measured task conditions to evaluate manual lifting demands. Its Recommended Weight Limit (RWL) and Lifting Index (LI) help assess demands related to lifting-associated low-back risk.

You need the load weight, hand locations, travel distance, twisting angle, lifting frequency and duration, and coupling quality. The ErgoFactor NIOSH calculator evaluates one task, including the origin and destination when required. It does not measure an individual worker's lifting capacity.

For hand and wrist tasks: Strain Index

The original Moore-Garg Strain Index uses six factors: intensity of exertion, exertion time within a work cycle, efforts per minute, hand/wrist posture, speed of work, and daily task duration. Multiplying the six factors gives a score with no units.

The ErgoFactor Strain Index tool evaluates one hand or both hands separately using the original six-factor method. It does not combine tasks into a whole-job score. The Revised Strain Index is a different model; keep its procedures and interpretation separate from the original method.

Match the method to the work

  • For a box moved between two work heights, consider the RNLE if the lift and conditions fit its scope. Record the load and lifting geometry; box weight alone is not enough.
  • For repeated hand-tool use, consider the original Strain Index. Record the force and exertion pattern as well as repetitions. A count of finished products does not describe all the hand demands.
  • For carton lifting followed by repetitive packing, assess each exposure with the appropriate method. Do not combine the LI and SI into one score.
  • For pushing a loaded cart, prolonged overhead work, or vibration, choose additional methods. Neither tool alone provides a complete assessment of those demands.

Read each score on its own terms

An LI compares the load with the RWL for that lift. An SI is the product of the original method's six hand-task multipliers. A score of 2 in one method does not mean the same thing as 2 in the other.

Use each method's interpretation and limitations when setting priorities. A lower result does not guarantee safety or provide a medical diagnosis. Check other exposures, whether the observed work is representative, and how proposed changes affect the job.

Custom Strain Index multipliers require expert judgment. The ErgoFactor tool does not assign its standard screening bands when custom multipliers are used.

Plan the assessment

Identify the task you need to understand before choosing a tool. Where the work varies, separate materially different tasks and consider the combined pattern of exposure over the workday.

Read How to Interpret the NIOSH Lifting Index for lifting guidance, or What Is an Ergonomic Risk Assessment? for the broader process. Contact ErgoFactor when work falls outside a tool's assumptions or you need help choosing improvements.

Sources